Trim piece removed, use your hands to pull it from the inside of the kidney area. *

This shows the top two screws you need to remove from the headlight. They are 8mm. *

This is how to remove the lower trim piece on washer and non-washer cars. *

This is the trim piece removed but not taken off the car. *

P1010375.JPG *

Rear bolt 8mm that needs to be removed. *

Inside kidney area screw. 8mm. Requires a magnet. Unscrew this - this is the 4th and final screw to remove. *

Slide the headlight out slowly. *

headlight slid out. *

P1010383.JPG *

High beam bulbs - use the original from your existing lights. *

P1010385.JPG *

Left to right:
Ignore the yellow/black wires with grey plug if you have Xenon package.
Use that plug if you have non-Xenon halogen.
The red/blue wires are xenon bulb, they connect to xenon ballast.
Ballast (ccfl) on top of the light connects to the wiring harness provided. *

P1010387.JPG *

Make sure the headlight slides in on the guides properly and make a small incision on the back of the "cover" to get the HID wires out. *

P1010389.JPG *

P1010390.JPG *

P1010391.JPG *

Mounting the ballast with DS tape. *

P1010393.JPG *

P1010394.JPG *

Inverter for CCFL.
Orion V2 does not have this part. *

Mounting the ballast (for CCFL only). *

P1010397.JPG *

P1010398.JPG *

P1010399.JPG *

The trim piece will not break but you need to be firm and make sure all the pins slide in properly. *

P1010402.JPG *

P1010403 *

Headlight adjustment using a low power screw bit on the flower adjustment wheel. *