Title:
Load Equalizers (Gold Error Correcting Resistors)
Product Description (may describe some optional equipment) :
LED bulbs may cause some newer vehicles to indicate a bulb is burnt out (because of their low power consumption). Some cars indicate this by increasing the flash rate of the turn signals, some turn on a bad bulb indicator. This can be remedied with our Load Resistors wired across the turn signal bulbs to simulate a standard resistance load for the Light Control Computer.This 6 Ohm, 50 Watt resistors should be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Amp load). This load is done by tapping (using the supplied blue taps) to the power and the ground connections.
This will solve LED related turn signal problems such as hyper flashing or burnt out bulb indications. This LED Load Resistor can be use with most signal or brake light which uses SINGLE or DUAL FILAMENT LED light bulbs, like the 7443, 1157, 3157, 4157, 1156, 7440, 3156 etc. Resistor measures 1.96L x .64W x .60H inches, leads are always between 6 and 12 inches long.
Includes/Instructions :
Includes blue or red t-taps (shown blue in product photo)
Using included splice taps, connect one wire to ground and the other wire to the 12V positive hot wire. Splice taps allow for installation without cutting your turn signal wires - they break the insulating sheathing without cutting the copper core.
Product Details:
6 Ohm 50 Watt resistors can be use will most import and domestic vehicles.
How to install
